2004 Clutch replacement ERGH
Thread Starter
Newbie - Just Registered
Joined: Jul 2018
Posts: 12
From: Indiana U.S.
2004 Clutch replacement ERGH
HEY EVERYONE!
Im new to the forums. So I’m sorry to start a new thread, but there likes 400 pages and I’m not finding anything about a clutch job on an 04 Max @ 20 pages in lol.
SO, does anyone have advice on removing the bellousing to change the clutch and flywheel?
I’ve done the clutch replacement on my 2000 Max and on the 2004 it’s a bit different/harder due to the differences like the subframe, gear box shifter on top & limited/tight space. I have the tranny pulled all the way back and the input shaft is all the way out. I can see the bolts to the pressure plate. But I CANNOT get that sucker out!
Does anyone know where a thread is for this?
Or would anyone know of any easier way of getting the Bell housing/tranny out WITHOUT removing the subframe?
Thamks guys!
Im new to the forums. So I’m sorry to start a new thread, but there likes 400 pages and I’m not finding anything about a clutch job on an 04 Max @ 20 pages in lol.
SO, does anyone have advice on removing the bellousing to change the clutch and flywheel?
I’ve done the clutch replacement on my 2000 Max and on the 2004 it’s a bit different/harder due to the differences like the subframe, gear box shifter on top & limited/tight space. I have the tranny pulled all the way back and the input shaft is all the way out. I can see the bolts to the pressure plate. But I CANNOT get that sucker out!
Does anyone know where a thread is for this?
Or would anyone know of any easier way of getting the Bell housing/tranny out WITHOUT removing the subframe?
Thamks guys!
Thread
Thread Starter
Forum
Replies
Last Post
Maxwell
4th Generation Maxima (1995-1999)
12
Apr 16, 2002 08:33 PM