update on my project
#1
update on my project
Well, project update. Got my shaft machine out and it's much stronger then my old one. So, take a look, I know some of you guys will flame about the hose I use. but for now it works. as for boosting? lets just say my POS BOV makes tweety bird chirp hahah! everytime when I floor it and let the gas. Pretty strong at 3500, but haven't had the ***** to go any higher...
http://www.cardomain.com/member_page...=304102&page=6
http://www.cardomain.com/member_page...=304102&page=6
#9
Thanks guys!!!
Addae, space is very limited. I try to relocating the MAF to the right side of the car that didn't happen, so I just left it as it is. I will stick with this setup for now, till something comes up again.
This piping or hose are flexilbe exhuast hose ( you see them on some big 18 wheelers) I got the aluminum ones, they do have SS or regular steel. Much easier to work with aluminum the steel and plus is much lighter. And yes I did save alot of money too. need to save up and get me a real BOV.. As for dyno? Maybe later.
Addae, space is very limited. I try to relocating the MAF to the right side of the car that didn't happen, so I just left it as it is. I will stick with this setup for now, till something comes up again.
This piping or hose are flexilbe exhuast hose ( you see them on some big 18 wheelers) I got the aluminum ones, they do have SS or regular steel. Much easier to work with aluminum the steel and plus is much lighter. And yes I did save alot of money too. need to save up and get me a real BOV.. As for dyno? Maybe later.
Thread
Thread Starter
Forum
Replies
Last Post
litch
4th Generation Maxima (1995-1999)
123
01-04-2024 07:01 PM
mkaresh
8th Generation Maxima (2016-)
21
03-12-2018 06:48 PM
Forge277
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
12
06-13-2016 09:26 PM