Question regarding vacuum fitting on intake pipe
#1
Question regarding vacuum fitting on intake pipe
On the intake pipe, there is a small 1/8" vacuum fitting. We just finished Jason Sadler's turbo, and on his piping, as of right now, we do not have that fitting welded in. Very hard to find 1/8" tubing. What I'm wondering is if it is absolutely necessary to put that fitting there, or can we just run the vacuum line to another vacuum source.
#4
Jeff is it the smaller line to the left of the LARGE line on my gray intake pipe, right in front of the TB?
Here my intake pipe for refference
http://www.turbomaxima.com/modules.p...ew_photo.phpis
Here my intake pipe for refference
http://www.turbomaxima.com/modules.p...ew_photo.phpis
#5
#6
yes kirk, that is the correct line we are talking about... I didn't have any steel tubing that size I could weld in, so I tapped one of the T'd vacumm lines, I think it was the wastegate line.
check my other post, car threw a couple codes when driving, wonder if this has anything to do with it?
check my other post, car threw a couple codes when driving, wonder if this has anything to do with it?
Thread
Thread Starter
Forum
Replies
Last Post
MAXSE5SPD
Other For Sale/Wanted
2
08-23-2015 12:06 PM
MaximaDrvr
7th Generation Maxima (2009-2015)
16
08-19-2015 08:20 PM