Im getting ready to install the harness, an wanted to make sure I have the right info.

So I dont trip the cel, I need to solder in 300ohm 1/4watt resistor, and so I dont melt the coil you solder in a 470ohm resistor.

 

you have to solder resistors? i havent installed my ignition harness yet but i didnt think you had to do anything extra than just wiring it up to the harness...?

 

You have to solder in diodes, but I'm not 100% sure, I did on mine but I heard if the emanage firmware is updated properly it shouldn't fry the coil packs.