does anyone here have an apexi auto timer installed in there car?

 

I have one, it works good.

 

alright I have some questions about the wiring. did you buy a vehicle specific harness?

they dont make one for the 5th gen so this is what I came up with so far :

gray - parking brake switch (which wire on the parking brake switch does this go to?)

black - ground

white - o2 sensor signal

red - 12 volt constant

blue - IG2 output (where is this and what is it?)

green - IG1 output (where is this and what is it?)

 

I didnt use a harness so I looked at the factory service manual to find the correct wires. I wired everything up except for the o2 sensor. Not sure if the wires are the same color but I can check for you tomarrow if I get a chance before work.

 

alrigh thank you

I know where the red and black wires need to go.

for the parking brake switch which wire does the gray wire tap onto? (ground?)

I can probably figure out the o2 signal wire

my main thing is figuring out the IG1 and IG2 output I have noe clue where that Is