simpleNclean's turbo build :)
#130
#131
that would be great to see, im trying to figure out how to do my wire tuck but dont know where to really start,
#133
@simpleNclean kevin dddddddaaaaammmmmmmnnnnn coming along really good bro
@Crusher103 thats me behind my buddies like simpleNclean said i yep its totaled i got another one now so cant wait till im done with that one
@Crusher103 thats me behind my buddies like simpleNclean said i yep its totaled i got another one now so cant wait till im done with that one
#136
turbo setup is coming along
turbosmart compgate 40
turbo manifold getting built by gato performance
front manifold done, turbo mounted
should be done this weekend. need to finish fuel system and get built tranny then its showtime
turbosmart compgate 40
turbo manifold getting built by gato performance
front manifold done, turbo mounted
should be done this weekend. need to finish fuel system and get built tranny then its showtime
#141
I hope you are ceremic coating or wrapping that manifold. I made the mistake of not wrapping my wastegate feed and it started to melt stuff im glad i caught it before it destroyed my harness. Make sure you keep that heat under control. Of course wrapping is better i can literally touch my downpipe at all times but it doesnt look pretty, you would probably opt for ceremic coating as it looks a lot cleaner. Have you picked out rad fans yet? Thats my next question. If i could do it over i would do an M3 like setup with 16" puller and a 14" pusher.
Otherwise looks really good man, hope you dont have issues like i am with my difficult car.
Otherwise looks really good man, hope you dont have issues like i am with my difficult car.
#143
im not on here much anymore, but i still wanna update this.
turbo hot side done.
peek-ah-boo
interfooler installed
turbine housing cermaic coated
intercooler piping done
buttoned her up to see how she looks.
so i had to take the motor out to get couple more things mocked up and ready for final installation. timing cover had to be powdercoated and upper oil pan need to be tapped and drilled for oil return line
also replaced all the timing cover bolts, pita
how the turbo kit looks without the feed from the rear
turbo hot side done.
peek-ah-boo
interfooler installed
turbine housing cermaic coated
intercooler piping done
buttoned her up to see how she looks.
so i had to take the motor out to get couple more things mocked up and ready for final installation. timing cover had to be powdercoated and upper oil pan need to be tapped and drilled for oil return line
also replaced all the timing cover bolts, pita
how the turbo kit looks without the feed from the rear
Last edited by NmexMAX; 11-05-2013 at 11:21 AM.
Thread
Thread Starter
Forum
Replies
Last Post
litch
4th Generation Maxima (1995-1999)
123
01-04-2024 07:01 PM
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM