Raced on 8-10-11 :(
#1
Raced on 8-10-11 :(
EDIT: FOUND MY SLIP!! It was the slip of my worst race which was a 16.8 but my phone is crap so i cant take a picture of it. but look at most recent post to see the numbers.
Raced at Island Dragway in New Jersey on wednesday the 10th. It was cheap and i was undecided when i got there, but it costed the same to race as it did to watch, so i did a couple runs... I dont think that i should have.
I drive a 99 maxima SE, with minor performance mods such as straight 2.5in pipe exhaust from flex to muffler, and intake.
My best run was a 16.7, with a launch of .426. needless to say It was embarrasing.
My car is almost due for the oil change, put a new filter on just before racing, and gave it a quart or two of oil. Any reasons my times were so slow other than it being a 12 yr old car?
Maybe its just me but i thought my car would have been alittle faster than that .
I was still able to beat a couple 2010 sentra's though .
Raced at Island Dragway in New Jersey on wednesday the 10th. It was cheap and i was undecided when i got there, but it costed the same to race as it did to watch, so i did a couple runs... I dont think that i should have.
I drive a 99 maxima SE, with minor performance mods such as straight 2.5in pipe exhaust from flex to muffler, and intake.
My best run was a 16.7, with a launch of .426. needless to say It was embarrasing.
My car is almost due for the oil change, put a new filter on just before racing, and gave it a quart or two of oil. Any reasons my times were so slow other than it being a 12 yr old car?
Maybe its just me but i thought my car would have been alittle faster than that .
I was still able to beat a couple 2010 sentra's though .
Last edited by Xfactor22; 08-19-2011 at 06:43 PM.
#7
Ouch .... this has to be an auto ... how many miles you got on that motor ?
Do a compression test on it
and practice makes perfect ... do the little maint. stuff and run it again ... if you find it embarrassing just ask them to put you down as NT (Hopefully they do that) that way the time doesn't show on the board and you just get a slip with everything
i went through the same thing when i first bought my car lol...i know how you feel
Do a compression test on it
and practice makes perfect ... do the little maint. stuff and run it again ... if you find it embarrassing just ask them to put you down as NT (Hopefully they do that) that way the time doesn't show on the board and you just get a slip with everything
i went through the same thing when i first bought my car lol...i know how you feel
#8
Ouch .... this has to be an auto ... how many miles you got on that motor ?
Do a compression test on it
and practice makes perfect ... do the little maint. stuff and run it again ... if you find it embarrassing just ask them to put you down as NT (Hopefully they do that) that way the time doesn't show on the board and you just get a slip with everything
i went through the same thing when i first bought my car lol...i know how you feel
Do a compression test on it
and practice makes perfect ... do the little maint. stuff and run it again ... if you find it embarrassing just ask them to put you down as NT (Hopefully they do that) that way the time doesn't show on the board and you just get a slip with everything
i went through the same thing when i first bought my car lol...i know how you feel
i have done a lot of rilling start racing and beaten a lot of faster cars, but from a stop it just seemed slow.
#11
Find that timeslip and post up a pic ... it'll help determine whats actually slowing your car down like that
and stripping your car should be the least of your concern ... 4thgens(5mt) should run 15's STOCK all day
#15
That reminds me that i had a knock sensor code last summer when my CEL was on, but it's not on now, so that might still be the problem. I'm looking to buy one as soon as i can and get a full tune up with fluids and filters.
Thanks for reminding me Tom
~Francis
Thanks for reminding me Tom
~Francis
#16
I think those year Maxs with 5spd should be doing like mid to high 15s in 1/4 mile. You got a y-pipe?? how about a clutch or lightweight flywheel? Those things would do wonders! I had a 97 Max (AUTO) with ypipe, high flow cat, Stage 2 transmission mod, CAI, eibach springs and KYB GR2s. It was pretty quick....even raced a Mazda RX8 and kept up with it.....until top end hit.....that things sucked at top but low to mid was great. It really wasn't even worth reving past 5500 rpm. But it was a great car!!
#17
I think those year Maxs with 5spd should be doing like mid to high 15s in 1/4 mile. You got a y-pipe?? how about a clutch or lightweight flywheel? Those things would do wonders! I had a 97 Max (AUTO) with ypipe, high flow cat, Stage 2 transmission mod, CAI, eibach springs and KYB GR2s. It was pretty quick....even raced a Mazda RX8 and kept up with it.....until top end hit.....that things sucked at top but low to mid was great. It really wasn't even worth reving past 5500 rpm. But it was a great car!!
#18
Found my slip, and my phone is too crappy to take pics with the small numbers and all. So i am just going to write them down.
Keep in mind this was a worse run than the orignal posted time, but only by .1 lol
R/T - .425
60' - 2.721
330 - 7.358
1/8 - 11.06
MPH - 66.28
1000 - 14.227
1/4 - 16.85
MPH - 86.07
Needles to say.... Frownface
Keep in mind this was a worse run than the orignal posted time, but only by .1 lol
R/T - .425
60' - 2.721
330 - 7.358
1/8 - 11.06
MPH - 66.28
1000 - 14.227
1/4 - 16.85
MPH - 86.07
Needles to say.... Frownface
#19
Found my slip, and my phone is too crappy to take pics with the small numbers and all. So i am just going to write them down.
Keep in mind this was a worse run than the orignal posted time, but only by .1 lol
R/T - .425
60' - 2.721
330 - 7.358
1/8 - 11.06
MPH - 66.28
1000 - 14.227
1/4 - 16.85
MPH - 86.07
Needles to say.... Frownface
Keep in mind this was a worse run than the orignal posted time, but only by .1 lol
R/T - .425
60' - 2.721
330 - 7.358
1/8 - 11.06
MPH - 66.28
1000 - 14.227
1/4 - 16.85
MPH - 86.07
Needles to say.... Frownface
driver mod = priceless
that is by far the worst 60ft I have ever seen
#20
with a new ks and 2.2 60ft you'll be in the high 14 to low 15sec range
to go any faster I would suggest a mevi/00vi, y-pipe, testpipe, exhaust and jwt ecu. then the car will be good for low 14's all day, high 13's depending on the driving and tires
to go any faster I would suggest a mevi/00vi, y-pipe, testpipe, exhaust and jwt ecu. then the car will be good for low 14's all day, high 13's depending on the driving and tires
Last edited by t6378tp; 08-19-2011 at 09:03 PM.
#23
I already have a straight 2.5 pipe after the flex...
i also found an 00vi im on the edge of purchasing just to get more respect from the numbers lol.
Thanks Thomas and everyone for the help, i will shoot you an update this week if i race.
P.S.- The 60' time is why i almost didnt post this. lol
#25
*facepalm*
have you ever had a Bad KS ?
It doesn't give your car X5 times the torque and make it spin to a 2.7 60 ft
he is an auto *facepalm*
The car is shot down to the ground and doesn't move for **** out the whole
i bet he didn't even spin AT ALL
There is no "Driver mod" here .... *facepalm*
#27
Yes, I had a bad ks before back when I 1st got my maxima and ran a 16.X when the car was a auto with a y-pipe and exhaust. A local org at the track had a scan tool and pulled a code for a ks eventhou I didn't have a cel. Replaced it at the track, reset the ecu and ended up running 5 tenths faster.
After that I got a cai, mevi and dr's and pulled a 14.5 as a auto and 14.2 as a 5spd. Never got a chance to run with the jwt ecu
After that I got a cai, mevi and dr's and pulled a 14.5 as a auto and 14.2 as a 5spd. Never got a chance to run with the jwt ecu
#28
#30
#32
awesome, thomas that chart did explain alot, and if i race this wednesday i will for sure take everything out of my car just to get as much out of it as i can.
Again, im not the best racer, but i enjoy doing it, just hope to get some better times with
my 5speed!
Again, im not the best racer, but i enjoy doing it, just hope to get some better times with
my 5speed!
#33
#35
Thread
Thread Starter
Forum
Replies
Last Post
followthadollar
4th Generation Maxima (1995-1999)
2
09-23-2015 08:31 PM