hey i was wondering about the toyota tercel crank shaft pilley, looks as it would fit our crankshaft also has a tooth in it but my question is really about the rubber lining in between the teeth and the actual pulley i just wanna kno will it slip inbetween each other if there is too much force on it i kno that i could weld it together but kust wondering about the pulleys with the rubber lining because i wana swap it with the pulley that i have on the maxima its a lot lighter and has only enough room for one belt, the 4 strander that im using...

 

You could just buy my UDP.

S

 

wel this one has only one belt and i think that its lighter?......

 

You sure about that? I doubt it's lighter, and mine is also smaller diameter.

S

 

what about the rubber in the middle?...