You got 1000 dollars to waste on your car? What mods do you get?

 

altezzas, carbon fiber lugnuts, 13" Daytons, sheepskin seats, yellow centercaps for my wheels, onion scented air freshener, 10 point wooden roll cage, chain link steering wheel, hydrolics, quad exhaust and dually wheel conversion in the rear....

 

on da project car...honduh boy?.... or DAMAX...?

 

 

Used VGT...$400
New bearings for it...$60
Manual boost control bleeder valve..$5
Junkyard fuel pump $35
Reprogrammed ECU...$500 (ouch! JWT don't hurt me!)

See where I'm going with this?

 

well my car is completely stock so far.

 

from where?? and with what type of compression readings??

 

Look hard enough, you can get them for less even. But so what. VG's are strong, toss in sealed power ring set, pull it apart , hatch-hone the bores and rering that thing. Heads can always be done after it's in there.

 

hmmm...dunno about that man, trust me I've been looking for the past year(till I scratched the plan), most of the complete used $500 models haven't been LD tested or have some too "unreliable" low cylinder compression(like ~120-130s)!

 

You're right, but you take your chances ya know? I'm trying to be optomistic. I really want a vgt max bad. Maybe I should just build a race car. If I didn't have student loans to pay back I'd be there! Damn education. Sallie Mae, suck this

 

But they dont make altezzas for our cars!!!

HEHEHEHE..... to altezzas

 

"they" don't make them, but I've seen them on our cars before though....

 

They suck

 

Anything's possible with the right amount of funds...

 

 

with 1000 dollars i would half way pay for bad VTC's if i had them

or i would just do the vgt swap

 

I would put VTEC heads from an Accord on my VE.