window washer fluid problem
#1
window washer fluid problem
My question concerns the window washer fluid system. When i spray the fluid it comes out all messed up and gets all over the hood. I took the the nozzels off the hood and they were clean. I could spray air and water through them fine. Then i checked the tubes that carry the fluid and they are all clear. So i assume its the pump. If anybody had any experience replacing their pump could you let me know if it was an easy task or a real pain in the a**. Also how much do you think it will cost me to replace the pump.....thanks
#2
Re: window washer fluid problem
If it sprays at all it shouldn't be the pump but I never had that problem before so I don't know. Do you know you can adjust wjere the sprayers spray. if you stick a little nail or something in one of the holes you can move them around. They are a pain to adjust they either go to far or not enough.
#3
yea if it sprays than it isn't the pump. the nozzle might have calcium buildup inside. anything that blocks the flow will have a wierd spray pattern when the water does come out. remove those washers and soak them in warm water with a lemon juice or vinegar for like 15 minutes. that should remove any calcium buildup. hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
sctludwig
3rd Generation Maxima (1989-1994)
8
09-01-2022 01:32 PM
markevans999
3rd Generation Maxima (1989-1994)
7
09-10-2015 04:29 PM
ef9
4th Generation Maxima (1995-1999)
5
09-05-2015 11:18 PM