vansskaterfreek

iTrader: (14)

well there is another post floating around about what i need to complete my swap of my VG / VE tranny... i curently have a VG auto... and i want to bolt a VE tranny up to my VG motor....now what needs to be replaced when i do this swap?????? should i change the axles??????? i am not doing springs/struts.....shoudl i replace any seals on the tranny (the ones you can see where axle goes into tranny??) what about wheel bearings?????? or seals for the wheels???? i wanna do this right.. but do not want it to get too expensive..... if the flywhel and torque converter is ok... ill just keep them since the car only has 69k on it

internetautomar

iTrader: (30)

the axles will need to be used from the VE as will the spindles.
The trans will physically bolt up.
I'm not sure on using the converter, I've Never looked.

89badmaxse

iTrader: (1)

dont forget to change your rear main seal on teh motor to avoid a nasty oil leak later...

internetautomar

iTrader: (30)

Good call, I always forget about that