My engine rocks back and forth quite a bit when I engage the gar into D or R as my engine mounts seem like they are done. The rear mount seems to be the worst one for wear....

I'd like to change all 3 mounts. The process doesn't seem that difficult, but I was wondering if I required any special equipment?

I have a 2-ton hydraulic trolley jack and jack stands.

Also, any recommendation on where to buy the mounts?

Thanks,

 

try your local nissan dealer. Parts like that are getting hard to come by elsewhere

 

Best option to gut your bad ones and fill them with poly. NOT WINDOW WELD. Real polyuerthane. I've installed 2 NEW ones from the dealer and the tore not even the next week. There's a guy that fills them, he did mine, if he still does them, he'll chime in.

 

Napa has them for about $70 each..

 

WTF are you smoking?
Every mount manufacturer of mounts makes them for the VG.
they are a piece of cake to get

 

pay me 20 bucks and i'll send you some...

lol j/k

my mistake than... alotta parts are getting harder to find, just figured the best place to look is the nissan dealer.

 

nah, they are getting easier to find. just don't go the big box stores who only care about A/B movers.

 

Thanks, I went to the local today to order. I should get them tomorrow.

 

I got an entire set off eBay for a little over $100 including the tranny mount. Check there first.

-Mark

 

Don't rule out WindoWeld!! It worked for me! 2 motor mounts for less than $20.

 

How long have you had these mounts on the car after refilling with W/W?