OEM GXE Fog Light Wiring (who the heck has 56K these days?)
03-04-2013 | 03:58 PM
#41
With the gxe fogs you will get lense+reflector. They are not like se at all. Even the Bosch seemed cheapo compared to the heavy se assembly. They have a metal spring/tab holding the lense on as well as very different mounts. I just ordered some no name ones from amazon. I will share pics when they arrive. I like the smaller size of the gxe fogs.
03-04-2013 | 10:49 PM
#42
Im curious whether the glass would be removable (so I can add yellow capsules) on the GXE fogs. Ive tried several different ways with the SE fogs and I cannot get the glass alone off. Too bad, too, since Ive got some capsules that would fit inside them perfectly
03-05-2013 | 06:21 AM
#43
there are 2 phillips screws behind the housing. undo those and the glass falls out revealing a H3 bulb.
03-05-2013 | 09:37 AM
#44
Its possible to remove the H3 bulb holder and add capsules. But once you move that original bulb holder; there goes the beam pattern..
03-09-2013 | 09:03 PM
#45
Member
Joined: Jun 2002
Posts: 230
From: Asheville, NC
Generic GXE fogs arrived today. They are glass, lens has "Luxpro" etched into it, sticker says "Eagle Eyes." They appear to be good quality.
Here's a comparison to the OEM SE fog:
To answer DMad8724's question the lens seems to be crimped onto the reflector, it doesn't seem practical to try and separate the two.
My question: does one of the lights need to be inverted? How to tell which one?
Here's a comparison to the OEM SE fog:
To answer DMad8724's question the lens seems to be crimped onto the reflector, it doesn't seem practical to try and separate the two.
My question: does one of the lights need to be inverted? How to tell which one?
03-11-2013 | 05:36 AM
#48
there is an "up" right? I think it matters which way they go in... since the light is intended to be aimed downward only.
Also does the SE fog have a plate inside it at the same height as the GXE fog's total height? Kinda looks like the actual light-output zone is the same size.
Also does the SE fog have a plate inside it at the same height as the GXE fog's total height? Kinda looks like the actual light-output zone is the same size.
03-11-2013 | 06:32 AM
#49
LOLOL. Im talking about removing the glass from the reflector itself. I know the reflector + glass removes from the housing with those screws. Im saying id like to seperate the glass from the reflector and add yellow capsules.
Its possible to remove the H3 bulb holder and add capsules. But once you move that original bulb holder; there goes the beam pattern..
Its possible to remove the H3 bulb holder and add capsules. But once you move that original bulb holder; there goes the beam pattern..
beam pattern...what that even a thought when nissan made these housings?
Thread
Thread Starter
Forum
Replies
Last Post
vingodine
5th Generation Classifieds (2000-2003)
45
05-21-2016 12:46 PM
Viralkill
7th Generation Maxima (2009-2015)
1
08-17-2015 10:54 AM
98nismomax
4th Generation Classifieds (1995-1999)
0
08-13-2015 12:44 PM