WTB:: Keyless Entry Remotes
05-26-2007, 06:03 PM
#1
WTB:: Keyless Entry Remotes
I need a remote for my maxima. never knew about reprogramming so i tempted and threw away my old working one about 2 years ago. LOL
Did some reading and tested, now need 1 or 2 remotes.
PM ME or
AIM- vuiskool
Did some reading and tested, now need 1 or 2 remotes.
PM ME or
AIM- vuiskool
05-29-2007, 07:06 PM
#6
1. Enter the car; close and lock all doors.
2. Put the key in ignition at least 6 times in 10 seconds and the hazards will flash twice. You just erased whatever remote settings were currently in the remote fobs.
3. Turn the key to the ACC position
4. Press the door lock button on the remote. The hazards will flash twice again.
5. Open drivers door and it will exit programing mode. To program more than one remote, skip this step and manually unlock the door and re lock the car with the **** on the driver's door, near the window switches. Then press lock on the second remote and if you see the hazards flash twice again, you have both remotes programed.
Hope this helps...it worked for me
2. Put the key in ignition at least 6 times in 10 seconds and the hazards will flash twice. You just erased whatever remote settings were currently in the remote fobs.
3. Turn the key to the ACC position
4. Press the door lock button on the remote. The hazards will flash twice again.
5. Open drivers door and it will exit programing mode. To program more than one remote, skip this step and manually unlock the door and re lock the car with the **** on the driver's door, near the window switches. Then press lock on the second remote and if you see the hazards flash twice again, you have both remotes programed.
Hope this helps...it worked for me
Thread
Thread Starter
Forum
Replies
Last Post