question for member who installed their own struts/springs...
#1
question for member who installed their own struts/springs...
I recently bought a set of used Eibachs and a set of new AGXs. Is there anything else I'm going to need to install these? My friend is going to help me install them at his body shop. I just want to make sure I'm not missing stuff. Thanks
btw....I know this has been covered before, but I wasn't getting the answer I was looking for by searching.
btw....I know this has been covered before, but I wasn't getting the answer I was looking for by searching.
#3
Spring compressor (as mentioned above), jack (duh) and at least 2 jack stands. Air compressor helps a lot. Also, my two bolts holding the front struts onto the steering knuckles were frozen on there., I used a propane torch to heat and they came off taht way.
#4
Member who somehow became The President of The SE-L Club
iTrader: (19)
Join Date: Jun 2001
Posts: 16,033
Re: question for member who installed their own struts/springs...
Originally posted by erty67
Is there anything else I'm going to need to install these?
Is there anything else I'm going to need to install these?
New Spring Isolators, 4 up front, 2 in the rear
New dust covers - OEM or KYB
#6
Originally posted by erty67
Thanks guys!
Thanks guys!
On the mount (above the above part, fits into it) - there is a "F". This faces Frontward.
Enjoy!
IanS
Thread
Thread Starter
Forum
Replies
Last Post
Cant_Get_Ryte
5th Generation Classifieds (2000-2003)
3
08-28-2015 06:41 AM