Feeding 4ga amp power cable into cab.....???
#1
OK, I am trying to get my power wire for my amp into the cab section of the car, and I can't find any way to get it through the big wall between the engine and the car. I have a '95 se auto, any information would be very helpful. I have the faq on how to install subs on the nissan w/ bose off of the maxima website, but it just says to the left of the fuel filter.... that doesnt help me much.
#3
here's what I did
remove the inside back of the driver side wheel well, just a couple screws. You should see a bundle of wires going in there thru a *HUGE* rubber grommet. I just sliced a little hole in that grommet and ran my 4ga. Easy peasy.
#4
Re: here's what I did
Originally posted by justmax
remove the inside back of the driver side wheel well, just a couple screws. You should see a bundle of wires going in there thru a *HUGE* rubber grommet. I just sliced a little hole in that grommet and ran my 4ga. Easy peasy.
remove the inside back of the driver side wheel well, just a couple screws. You should see a bundle of wires going in there thru a *HUGE* rubber grommet. I just sliced a little hole in that grommet and ran my 4ga. Easy peasy.
#5
I just got a hole drilled through the firewall. I brought to an audio shop to drill the hole because it is a pain drilling though the steel and it's hard making sure you don't hit anything else. They charged me $20 and it took like 10 min
Thread
Thread Starter
Forum
Replies
Last Post
Forge277
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
12
06-13-2016 09:26 PM