I posted last night about my CEL, turns out my fault. I got o2 sensor codes. we cleared the codes and all is well. turns out my being stupid and not really paying attention, i pulled the o2 fuse and fuel pump fuse and it shot a code out. all set with that..

now for the GOOD..




YEEE HAW!!!

am i getting myself to excited at this point? I am probably hyping myself up.. lol

 

nice!

do yourself a favor and either wrap that flex section or get a lined one put on. the rattle snake sound gets on your nerves...

 

i'm gona have to wrap my budget, i'm gettin that annoying rattle. But i love the gains, Its a small compromise to make.

 

what do i wrap it in?

 

Duct tape.
















heh.. use header wrap I believe.

 

yeah get 15' of header wrap for $15 and that'll cover the flex section nicely. smells for a lil while but that goes away.

 

header wrap can be purchased at ...? autozone/pepboys or hardware shop?

 

Wont hurt to wrap the whole pipe will it?

 

I think I'm the only one with no hissing from my Budget. All I hear is air rushing through the pipes, a very raw sound. Only hissing I have is my intake which makes it sound like I have a leak somehwere...

 

i would lke to know this as well.. where can it be purchased? and is it alright to wrap the whole y pipe?

 

Your local race shops will have it. It's popular to wrap headers and exhaust manifolds on bracket cars to reduce engine compartment heat, for cooler intake air and higher pressure exhaust. I bought a couple of 2"X50' rolls from JC Whitney online. Expensive stuff, $30+ a roll. I wrapped the whole Y pipe like the motorvateca.com guy did to his max. I wrapped the B pipe too, as there was factory insulation on the stock one to prevent heat from radiating toward the gas tank. Now to see how this stuff holds up to the test of time. I'm assuming it'll rot off after a couple of years of daily use!

 

No hisss here.......