Power antenna not working. Is this what i need to fix it?
Power antenna not working. Is this what i need to fix it?
http://cgi.ebay.com/ebaymotors/ws/eB...category=33639
The motor works when i turn on the FM/AM, but there is no antenna. It is how I bought the vehicle. Is that all I need to fix it.
Thx
The motor works when i turn on the FM/AM, but there is no antenna. It is how I bought the vehicle. Is that all I need to fix it.
Thx
Originally Posted by steveme
http://cgi.ebay.com/ebaymotors/ws/eB...category=33639
The motor works when i turn on the FM/AM, but there is no antenna. It is how I bought the vehicle. Is that all I need to fix it.
Thx
The motor works when i turn on the FM/AM, but there is no antenna. It is how I bought the vehicle. Is that all I need to fix it.
Thx
Originally Posted by steveme
FM works am is not so much. there is no antenna. Its just the hole going into the motor. the previous owner said it was broken and never fixed.
As long as your motor is working, then the mast off of e-bay is what you need. I purchased the same/similar mast a few months ago. My antenna was in place; it just didn't go up and down.
The only possible problem is that there is a broken piece of the plastic thread from the antenna still down in the motor. If you get the new mast, you will need to turn the radio off, so that the motor tries to retract the antenna. While the motor is doing this, feed the new thread down into the hole and it should grab on.
If there is a piece of the old thread in the motor, you will need to remove the motor from the side-wall (inside the trim panels inside the trunk), take it apart and remove the old piece. Good luck
The only possible problem is that there is a broken piece of the plastic thread from the antenna still down in the motor. If you get the new mast, you will need to turn the radio off, so that the motor tries to retract the antenna. While the motor is doing this, feed the new thread down into the hole and it should grab on.
If there is a piece of the old thread in the motor, you will need to remove the motor from the side-wall (inside the trim panels inside the trunk), take it apart and remove the old piece. Good luck
Thread
Thread Starter
Forum
Replies
Last Post
lowpost99
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
9
Oct 26, 2025 06:53 PM
Violator
4th Generation Classifieds (1995-1999)
1
Sep 9, 2015 10:14 AM



