WTF more tranny problems
08-24-2004, 06:35 PM
#1
WTF more tranny problems
so i jsut finished installing a cai, and y pipe on my max as im waiting to get new axles 
and my lil brother helped me in the install, after i put everything on i went to the kitchen to get some water all happy that i got this **** done, and then i hear my lil bro turnign the car on and start revign the engine , i didnt think nothign of it, then i hear a loud grinding sound..... i freaked out and ran back in the garage and my bro already turn the car off... i was heated and asked this **** wtf he did and he told me he just turned it on to play with it and then try to put it into park to turn it off.
so i went to go turn the car on and sure enough the loud grinding sound is still there, i quickly switched it out of park into R then N and then D and there was no noise, so i though it was gone and i tried to put it back into park and there it is again, scared the **** out of me, i had to put it in N turn off the car then P then take out the key... mind you all this is WITHOUT the CV shaft in!!
can someoen with knowledge help me? WTF did this do to my car? am i phucked
im beat the **** out of this **** tonight when hes sleeping too, ounk *** kids pleasse help!!!!111111
and my lil brother helped me in the install, after i put everything on i went to the kitchen to get some water all happy that i got this **** done, and then i hear my lil bro turnign the car on and start revign the engine , i didnt think nothign of it, then i hear a loud grinding sound..... i freaked out and ran back in the garage and my bro already turn the car off... i was heated and asked this **** wtf he did and he told me he just turned it on to play with it and then try to put it into park to turn it off.so i went to go turn the car on and sure enough the loud grinding sound is still there, i quickly switched it out of park into R then N and then D and there was no noise, so i though it was gone and i tried to put it back into park and there it is again, scared the **** out of me, i had to put it in N turn off the car then P then take out the key... mind you all this is WITHOUT the CV shaft in!!
can someoen with knowledge help me? WTF did this do to my car? am i phucked
im beat the **** out of this **** tonight when hes sleeping too, ounk *** kids pleasse help!!!!111111
08-24-2004, 09:58 PM
#3
UPDATE ok jsut pull some codes off the ecu
1) 3L3S=Front Left Heated O2 sensor
2)2L1S=Ignition Signal Circuit
3)3L4S= knock sensor
my knock sensor has been goign off for a while but first time i seen these 2 other codes, i cant see how they would be related to the noise
[please help!!
1) 3L3S=Front Left Heated O2 sensor
2)2L1S=Ignition Signal Circuit
3)3L4S= knock sensor
my knock sensor has been goign off for a while but first time i seen these 2 other codes, i cant see how they would be related to the noise
[please help!!
08-24-2004, 10:44 PM
#4
Supporting Maxima.org Member
Join Date: Jan 2004
Location: Olympia, wa
Posts: 186
Yeah not good
All i know is that when you pull the axels that area in the tranny should not spit what so ever. So i would say your little bro put it in gear as well then the really could have screwed something up. I am not sure but i know it is not good at all. I have always just been told when doing axels to make sure not to spin the area in which the axel is inserted in. It will harm the tranny.
08-25-2004, 05:18 PM
#5
Supporting Maxima.org Member
Join Date: Apr 2004
Location: temple hills, md
Posts: 453
what probably happened was the park prag/rod inthe trans was damaged by shifting the trans into park without stopping the forward motion of the trans--see w/o the axles in the trans, the brakes can't stop forward/drive in the trans. what happened was the same as if you were driving and put the car in park w/o stopping. hope it doesn't cost you too much to fix-trans shop or replace. if you're lucky no real damage was done.
08-25-2004, 05:20 PM
#6
hmm... I done that before in my 85 volvo. was going 15mph, tried to shift to neutral to rev at somebody, but missed and hit park. Oh my gosh, it was embarassing, and the back wheels locked up after a nasty "crunch". Haha. I learned my lesson. Car still drove fine. I hope yours ain't too bad.
Jae
Jae
08-25-2004, 07:25 PM
#9
Oh yeah i forgot to meantion! i went into his room at like 4 in the morning and snuff him into the pillow and gave him at least 30 body shots, i know those hurt cause when i was hitting his side he was squealing like a lil *****. i think i almost choked him to death....then i stopped cause i got scared i was really hurting him . im about to sell his stuff if i have to dish out $$ to fix the car, he gota computer, ps2, guitar and soem other crap.
08-25-2004, 08:02 PM
#10
Originally Posted by goodhead
Oh yeah i forgot to meantion! i went into his room at like 4 in the morning and snuff him into the pillow and gave him at least 30 body shots, i know those hurt cause when i was hitting his side he was squealing like a lil *****. i think i almost choked him to death....then i stopped cause i got scared i was really hurting him . im about to sell his stuff if i have to dish out $$ to fix the car, he gota computer, ps2, guitar and soem other crap.
Daymn thats mean. Maybe he'll learn his lesson. In the end he's your brother and its just a car. Keep cool, you'll be ok.
08-25-2004, 10:06 PM
#11
well my lil bro is kinda a ***** and i think its brotherly duty to tuff him up, hes turnign 14 and i love him and all but freshmen yearin high school i know hes gonna get into some fights so its only good for him, i mean i dont want to see my bro get his *** beat and him crying like a girl by some random kid tahts my job 
. besides he hit me in stomach with a baseball bat the other day by accident and i guess im still ****ed about that too, we are at leasteven for that hehe
. besides he hit me in stomach with a baseball bat the other day by accident and i guess im still ****ed about that too, we are at leasteven for that hehe
Thread
Thread Starter
Forum
Replies
Last Post
pktaske
6th Generation Classifieds (2004-2008)
1
05-06-2016 07:49 AM
pktaske
6th Generation Maxima (2004-2008)
0
09-04-2015 08:40 AM