Crankshaft Position sensor ECU Code...
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2004
Location: North Atlanta, GA
Posts: 348
Crankshaft Position sensor ECU Code...
I had this code since this weekend. I finally reset it today and it hasn't come back. This is a good thing, right? Or is there something I should be looking out for?
I have a buddy that works at a shop and they pulled the code and looked it up and there is a TSB that the wiring harness can rub against the power steering pulley and/or belt causing it to short. I checked it and this is not the case here.
Opinions/comments?
I have a buddy that works at a shop and they pulled the code and looked it up and there is a TSB that the wiring harness can rub against the power steering pulley and/or belt causing it to short. I checked it and this is not the case here.
Opinions/comments?
#3
Senior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2004
Location: North Atlanta, GA
Posts: 348
I do have hard starts. I find that if I leave the key on the on position (gauge lights come on) for a few second first, she'll start up about regular. I thinking it's a lack of gas. It may just take a few seconds to get it primed or something.
Also, my CEL didn't come back. She's driving normal too so I guess it was just a temp thing...
Anyone else have input on hard starts?
Also, my CEL didn't come back. She's driving normal too so I guess it was just a temp thing...
Anyone else have input on hard starts?
Thread
Thread Starter
Forum
Replies
Last Post
6spd4dsc
5th Generation Classifieds (2000-2003)
4
03-04-2016 05:19 PM
James92SE
1st-3rd Generations Classifieds (1981-1994)
4
10-08-2015 04:57 PM
QueensMAX
5th Generation Maxima (2000-2003)
7
09-15-2015 04:14 AM