Fuel Injector O ring Replacement
#1
Fuel Injector O ring Replacement
I am finally going to tackle replacing some bad fuel injectors. I picked up some used injectors that spec out fine. I want to replace the two O rings on each injector. The injector has a small plastic cap with 4 prongs that holds the lower 0 ring in place. It seems that the only way to remove the O ring is to remove the cap.
- On a couple of the injectors the cap is cracked. Any idea where I can get new caps? I read somewhere that someone makes a seal kit that includes new caps.
- Is it possible to remove this cap without cracking it? If so then I can remove them from my old injectors.
Thanks
Vince
- On a couple of the injectors the cap is cracked. Any idea where I can get new caps? I read somewhere that someone makes a seal kit that includes new caps.
- Is it possible to remove this cap without cracking it? If so then I can remove them from my old injectors.
Thanks
Vince
Thread
Thread Starter
Forum
Replies
Last Post
kjlouis
4th Generation Maxima (1995-1999)
11
11-24-2018 06:09 AM
Finkle
4th Generation Maxima (1995-1999)
13
09-27-2015 09:53 PM