SMX95

iTrader: (8)

I took 2 pics of these engine mount inserts. I wanted everyone to see how they are. I haven't installed them yet, im waiting for everything else to come. (New trans mount, New brake pads, New rear o2 sensor, New front slotted brembo rotors.) I spoke to brian cattman on the phone for 25 min, he was answering the many and many questions I had about these. He highly recommended these over PR mounts. PR mounts cause's vibrations at idle. These are a lot less to the point where it might not even be noticable. He had both of the mounts tested in his own car so the man wouldn't lie about this. I will give you guys my honest thoughts when they get installed.

2 Da Max

iTrader: (2)

nice. how much do they go for? btw you still want an lt1?

SPiG

iTrader: (7)

Cattman doesn't make these. He resells them from Energy Suspension.

I have had a set in my car for a while now. I love them. I still get wheel hop but I am not sure if my side motor and tranny mount are in good condition. Every other bushing and piece of rubber I have seen on my car has been trashed so I will probably fill them in the near future.

SMX95

iTrader: (8)

They were about $85 or $87 shipped to my door from cattmanperformance in cali. I wouldn't sell my car with the problems it has. I would need to fix up everything therefore that's why Im buying repair parts. And no I dont want an LT1 I want an LS1 its like saying if you want the 3.0 maxima or the 3.5 maxima. 98+ trans am and camaros come with ls1 anything lower than that year is lt1.

SMX95

iTrader: (8)

Any vibration's at idle?? Im very picky about this..