Programming A New Remote
#1
Programming A New Remote
I was looking across the internet and came across this.. Dont know if this a re-post but this might be useful information to someone.
Programming a new remote on a 4th Gen
Get in the car. Close and lock all doors with the driver's switch. Insert and remove the ignition key over six times in l0 seconds. Do it at a rate of one insert/remove cycle per second. Be sure you completely remove the key each time. Turn ignition to ACC and press any button on the remote once. If the hazards flash twice, it worked! If you want to program more than one remote, unlock and lock the doors again with the driver's switch and press a button once on the next remote.
Programming a new remote on a 4th Gen
Get in the car. Close and lock all doors with the driver's switch. Insert and remove the ignition key over six times in l0 seconds. Do it at a rate of one insert/remove cycle per second. Be sure you completely remove the key each time. Turn ignition to ACC and press any button on the remote once. If the hazards flash twice, it worked! If you want to program more than one remote, unlock and lock the doors again with the driver's switch and press a button once on the next remote.
#5
audible lock signal?
Is there a way to have the horn beep when locking the car? It would be much easier than looking for the lights....
Thread
Thread Starter
Forum
Replies
Last Post
Omar Abdurrahman Siddiqi
5th Generation Maxima (2000-2003)
33
08-26-2016 05:18 PM
ToTheMax305
7th Generation Maxima (2009-2015)
0
09-23-2015 09:11 PM