appleman

i need a new input shaft bearing put in my tranny. assuming i take the trans out and bring it somewhere how much do you think a typical rebuild will cost. ?
also does anyone know a good tranny place on long island , ny

WielkiWaac

iTrader: (8)

i called one shop and i was told 600$ just for labor plus parts

DRIFTA_187

i know this is off subject but i recently bought a new clutch for my car i put it in but i cant get any presure throughout my clutch system does any one know what the problem could be all the bleeder valves where closed i almost think it is the clutch master cylinder but im not 100%. the only reason i am posting this here is because i havent replied to enough post to fully activate my account

zazon

iTrader: (4)

threadjacking is a no-no.

anyways, when i was having pressure issues i just started replacing parts starting with the slave cyl (cheapest).

Zach95SE

iTrader: (3)

Yeah that's about what I paid. It was about $600 for labor and then about $200-250 for the bearings and seals. I think it was just over $800 before my discount.

konak85

iTrader: (10)

Did they put the proper shims?