prepare for some n00bish questions. I have an emanage blue and I'm setting it up for the first time with my Maxima.

I basically just want to plug it in and run defaults so I have set all air flow and timing to 0's.

In some of the settings i'm a little confused as to what to put.

For the MAF sensor (and I am running the stock A32 MAF) I assume it is either NS_HW-2 or NS_HW-4??

I know the rotary switches are 7-0-1 and I have set these accordingly.

So with these basic settings I have uploaded the fuel and timing maps filled with 0's to the main unit (as it says in the emanage support tool software) in a hope it will just run a default so I can take it down to the shop for a tune.

However, if I drive it, it seems to get to 2,500rpm and not want to rev past that point. I am wondering if my TPS wire isnt connected properly and it isnt registering - but thats just a theory.

Does anyone know if all the below is right??? Nothing I try seems to be working...



A big thank you to anyone who can help me

 

Change the maf setting and then it will work. If you can't rev past 2500 then the ECU is NOT receiving the proper maf signal

 

Thanks dude. NS_HW-2 seemed to clear it up. I did think I tried that, but obviously didnt export the settings??? my bad...