GoldMax96

About 4 months ago my buddy installed a full greddy sp2 exhaust on my car...the b-pipe is hanging incredibly low to the ground and when it is wet out or raining the b-pipe rattles like crazy against my gas tank and is very loud and annoying to listen to...does anyone have any advice on how i could get that to stop.


thanks

JOMAN

iTrader: (3)

i have/had the same problem..what fixed it was subaru exhaust hangers for me, i got them from a buddy it was a bit(h to put on but it fixed it....try that mayb that will help your rattles

th0ught

iTrader: (7)

Your muffler's hanger aren't supporting your catback well enough, causing your B-Pipe to sag. Replace the old ones with stronger hangers and you should be set.

dralucard

iTrader: (6)

try loosening the bolts and re-aligning the pipe. also get some new hangers.

LeVeL

Damn son, your exhaust is BANGIN

GoldMax96

yea i used the same hangers from the stock exhaust so ill try getting stronger ones

mtrai760

iTrader: (19)

Google Walker Exhaust, they make replacement hangers that are much stiffer than stock, and don't cost an arm and a leg. NAPA stocks them.

Snypa

iTrader: (35)

different/newer hangers shud do tha trick.

MaximaPimpin

iTrader: (3)

I took mine to a local exhaust shop, they fixed me up by putting on new hangars, only took them 10 minutes and it only cost me $10. I cant hear a thing now from my exhaust other then the muffler.

Brudaddy

iTrader: (2)

I had/have the same problem. It is just your hangers, like everyone else said. Mine still does it, but only when I get some wheel hop or something like that.

WhiteA32

iTrader: (20)

mine does the same thing. I even replaced the hangers with the walker ones. And it still does the same

andrei3333

go to a muffler shop and get them to weld on a tighter hanger, problem solved

craigism

Well after I read this thread, I went to Midas and they wanted to charge me over $500 for new exhaust. I said can't you just put new hangars on the B-pipe (my rubber supports were intact). They finally said that they can make "an improper temp. repair" for $179 and its this expensive because of all the labor to fabricate. I left with the quote thinking that were ripping me. Do I need a muffler shop or can most body shops attach hangers like the ones from Napa? Do these need to be welded?

I posted my progress here:
http://forums.maxima.org/4th-generat...ng-b-pipe.html