Can't get the hazard light to illuminate ... ??
#1
Supporting Maxima.org Member
Thread Starter
iTrader: (2)
Join Date: Sep 2003
Location: BROOKLYN NY
Posts: 349
Can't get the hazard light to illuminate ... ??
So I am a little stickler when it comes to interior lights all glowing. In my max all the interior lights illuminate with the exception of the hazard light. It works normally when you engage them (hazards work). However it does not illuminate. (when you turn the lights, as well as when you engage it {red color}).
So far;
1. tried 3 different hazard swithces (all same result)
2. Made sure that the fuse was good (plus changed out the fuse)
Any comments ... thank you
So far;
1. tried 3 different hazard swithces (all same result)
2. Made sure that the fuse was good (plus changed out the fuse)
Any comments ... thank you
#3
Member who somehow became The President of The SE-L Club
iTrader: (19)
Join Date: Jun 2001
Posts: 16,033
Replace the blub inside the switch. There are two of them, make sure you get the right one. You can pick up a replacement at Radio Shack. Seems the hazard button is among the first lights to die, so I'm not suprised if your used switches didn't work either.
#4
Supporting Maxima.org Member
Thread Starter
iTrader: (2)
Join Date: Sep 2003
Location: BROOKLYN NY
Posts: 349
I found 1 of them ... there is a red little rubber piece. Then there is a white plastic piece (light bulb goes inside), then there is a (1) small little light bulb with 2 wires sticking out, I'm assuming that is what I need??
So where is the 2nd one again?
#11
Supporting Maxima.org Member
Thread Starter
iTrader: (2)
Join Date: Sep 2003
Location: BROOKLYN NY
Posts: 349
For all of those that replaced the light bulb ....
1. So I opened the hazard switch, inside it I saw a red plastic cover (covering the light bulb), and the light bulb sits in a white plastic piece. The light bulb has 2 wires running out of it.
2. So I went to Radioshack, and boght the same light bulb, the only thing is the 2 wires were much longer then on the original. Anyhow, I put the 2 wires through the white plastic piece, and then cut the remaining length. But I don't think I did it right.
I am not sure how to assemble the wires. (where/what to pry)
Thank you!
1. So I opened the hazard switch, inside it I saw a red plastic cover (covering the light bulb), and the light bulb sits in a white plastic piece. The light bulb has 2 wires running out of it.
2. So I went to Radioshack, and boght the same light bulb, the only thing is the 2 wires were much longer then on the original. Anyhow, I put the 2 wires through the white plastic piece, and then cut the remaining length. But I don't think I did it right.
I am not sure how to assemble the wires. (where/what to pry)
Thank you!
#12
how to replace hazard button lights?do ihave to just pry the button outside or i have to remove the entire switch?thanks in advance
Thread
Thread Starter
Forum
Replies
Last Post
fastcarny
5th Generation Maxima (2000-2003)
2
10-06-2015 10:42 AM
Maxima30
5th Generation Maxima (2000-2003)
2
09-07-2015 06:13 PM