MAP sensor issue
#1
MAP sensor issue
I have a CEL (I believe it's p1105) I've had it checked at autozone numerous times, and it's only been my MAP sensor showing a fault. I've replaced it twice, code still won't go away. With that said, I have the 00vi put in about 3 or 4 months ago and the shop that did it set it up correctly, but re-did several vacuum lines. Can somebody tell me where the lines are supposed to go to/from, and if possible put up a pic or 2? I know that's asking alot, but it's not like a can look at a stock one since mines already been changed.
Thanks for you time in reading this!
Thanks for you time in reading this!
#2
http://www.nicoclub.com/FSM/maxima/1999/EC.pdf
EC-18 has the page of vacuum diagrams.
http://www.nicoclub.com/FSM/maxima/2000/ec.pdf
EC-26 has the '00 vacuum diagrams.
I already see a problem, you're missing the map/baro solenoid thingy on the '00 and that could have been left unconnected when the swap was done...
EC-18 has the page of vacuum diagrams.
http://www.nicoclub.com/FSM/maxima/2000/ec.pdf
EC-26 has the '00 vacuum diagrams.
I already see a problem, you're missing the map/baro solenoid thingy on the '00 and that could have been left unconnected when the swap was done...
Last edited by aackshun; 01-11-2012 at 12:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post