max ride 41

iTrader: (4)

for some reason, the hid's did'nt kick on after i stopped to pick up some stuff at the store. i pulled the 15 amp fuses and 1 looked blown so i replaced it. still nothing, don't know what else to check other than maybe under the dash or a relay? i don't hear the ballast's pop on when i turn the switch either. i noticed lately that when i turn on the high beams the headlights go off completely and i have to switch the lights off and back on to get them to work. what's going on?? thanks

CallMeThatOneGuy

iTrader: (2)

bad ballasts? my high beams never work right. and i have had both of my ballasts go out almost at the same time

Fakie J Farkerton

iTrader: (51)

What brand/company are the ballasts from?

max ride 41

iTrader: (4)

ddm hid tuning/ 4300k kit edit: just went out to look at wiring harness, just checked to make sure everything was connected and they popped back on!! wtf, i looked at the chopped up wiring job the guy did, ( another orger from 3 years ago ) and would'nt be surprised if that was part of the problem. at least i know the fuses are working. what could've came loose to make them go off like that?

maxgtr2000

iTrader: (29)

Any loose or corroded connection can cause that. Wires that are spliced should be soldered then shrink wrapped or electrical tapped.

Amerikaner83

iTrader: (17)

agreed Solder and heat-shrink is the BEST way to ensure a good connection.

max ride 41

iTrader: (4)

well, all wires were good, the ground was a tiny bit loose to the battery, and one of the fuses was blown, replaced fuse, tightened ground, all good!!!