reMaxxxK

iTrader: (20)

The "How To" in the stickies didn't clearly state that installation of side bracket on trailling arm where there is brake line run along it.

Wonder how you guys get away with it? unbolt the braket holding the brake line and later tie it back with cable tie?
could it be be run "in" the "U" side bracket?
any pic of it will be great help, thanks

Puppetmaster

iTrader: (48)

Yeah, ya need to remove that bracket. Soonerfan and I both have our cables ziptied to the trailing arm. Just use 2-3 zip ties along the length of it and you will be fine.

I would take pics, but I won't be getting my new camera until at least tomorrow (old one is dead).

reMaxxxK

iTrader: (20)

guess no other way huh, anybody else have clue or custom made a bracket for it to screw it back to the trailing arm

Bluesbrekr

iTrader: (4)

What brand of RSB are you installing? I have an Addco (Progress) and I did not need zip ties. The cable was able to remain in the bracket...just had to bend it a bit.

SoonerFan

iTrader: (5)

the instruction say to remove that bracket. the RSB comes with the zipties to use

Lontar1

iTrader: (5)

you can still bend the bracket alittle bit and screw it back.

wavedog

Yea , what brand. I have stillen and didn't have to use ties.

SoonerFan

iTrader: (5)

stillen mounts differently so you dont have to use the zipties.
you only need to do that for the progress one

rbrown81

iTrader: (3)

How is the stealin' sway bar Btw?

reMaxxxK

iTrader: (20)

guess Progress did need ziptie, stillen didn't, and mine are progress

Puppetmaster

iTrader: (48)

Just remove the bracket and zip tie it, nothing wrong with that method... or if ya find some creative way to bend the bracket, then go for it.

SoonerFan

iTrader: (5)

does the exact same thing for a lot more money