Hey guys i just installed my berk intake with the apexi filter on my 03 maxima..After installation i took it out for a test spin, awsome! I have a concern after that when my engine was warm, say i parked my car and filled up, turned off the motor. When i started it back up it would just die on me...i would have to mess with the throttle a little bit and then it would idle normally again, is this the ECU trying to learn again because i did unplug my batt for 24 hours if that helps, it hasn't stalled recently and has been pretty good i just want to make sure everything is ok!

Thanks

 

u might have messed up your MAF sensor if it just "died". Did u drop the sensor or could have possibly damaged it? Any Check engine lights?

 

On our 5.5 gens we have no reason to unplug the battery, try to reset the ecu here is a link to instructions on how to
http://www.technosquareinc.com/350reset.htm
Did you get a cel light? Hope the reset helps but it definately sounds like a maf problem

 

No CEL or anything car runs fine now i have no idea why it did it. Ill try reseting if i encounter any problems i guess.

 

if it runs fine i guess ur good. just check the vacume hoses, could be a maf but unless u droped it while changing its unlikely.