4gen FSTB on 5gen? possible?
check it out:
http://www.chrislehr.com/maxima/fstb.html
scroll down to the end for the pic you are looking for...
http://www.chrislehr.com/maxima/fstb.html
scroll down to the end for the pic you are looking for...
Originally posted by LoveSick
I am really wondering if the 4gen FSTB will work on 5gen Maxima!?
If you know, please tell me. I am planning to get one from Greg.....
I am really wondering if the 4gen FSTB will work on 5gen Maxima!?
If you know, please tell me. I am planning to get one from Greg.....
Sort of. You saw the reply noting that you have to cut into the air box bracket, but there is another problem. The 4th Gen bar does not raise high enough over the wiring harness at the back of the engine. You actually have to push the bar down on the wire harness during the install. This is not good -- the engine moves around a little during driving while the strut bar does not. I would expect some insulation to eventually be cut or worn off to cause a variety of problems. I would stick with a bar that fits.
Originally posted by LoveSick
I am really wondering if the 4gen FSTB will work on 5gen Maxima!?
If you know, please tell me. I am planning to get one from Greg.....
I am really wondering if the 4gen FSTB will work on 5gen Maxima!?
If you know, please tell me. I am planning to get one from Greg.....
Originally posted by irvine78
o~k...the 4th gen front strut tower bar will NOT work on a 5th gen. reason? because, the 5gen engine has higher intake manifold which prevent you from using a straight FSTB...if you look at a 5th gen FSTB and a 4th gen FSTB, you'll notice that it's different..
o~k...the 4th gen front strut tower bar will NOT work on a 5th gen. reason? because, the 5gen engine has higher intake manifold which prevent you from using a straight FSTB...if you look at a 5th gen FSTB and a 4th gen FSTB, you'll notice that it's different..
Originally posted by LoveSick
I am really wondering if the 4gen FSTB will work on 5gen Maxima!?
If you know, please tell me. I am planning to get one from Greg.....
I am really wondering if the 4gen FSTB will work on 5gen Maxima!?
If you know, please tell me. I am planning to get one from Greg.....
then again .. that logic has cost me close to $3200 CDN since I bought this beast!
so it mite not b a bad idea 2 ignore that ... n e ways ... they do have 'em cheaper ... check out eBay ... perfect fit 5th gen fstb 4 a lot less .. even courtesy has one for $89 ... but I think eBay mite b cheaper ... not 100% sure ...
Thread
Thread Starter
Forum
Replies
Last Post
Nismo87SE
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
2
Nov 1, 2000 06:11 PM




