Annoying rattling sound at 1800-1900rpm's.
The Nissan tech said that sludge is causing a rattle only at 1900-2200rpm? lol....And that the fix is to change everything timing related?...lmao......ok, I so wish I went to mechanic's school cause they get paid like $70/hr to say crap like that to people...Best laugh i've had all night...thx...
Junior Member
Joined: Jun 2003
Posts: 26
From: Cincinnati, OH
Rattle, not pinging
I've got a similar sound coming around the same RPM. It sounds more like a rattle/buzzing. Like a piece of sheet metal vibrating at resonance. It never happens while in park or nuetral, only onder load. I checked my cat heatshield, and could not find anything wrong there. I have had the P0133 code come on 9 times over the last 20K miles. Maybe i should change it, and see if that eliminates the rattle.
Newbie - Just Registered
Joined: Oct 2008
Posts: 1
From: Casselberry, FL
Not a wear issue
My Maxima has been making this sound since a couple of weeks off the lot after purchasing new in October 2001. I have never had the problem properly diagnosed, but I know that it is not related to sludge, low oil, or any other wear issue. The earlier post regarding multi-pot fuel injection is the most plausible explanation that I have heard.
Newbie - Just Registered
Joined: Aug 2002
Posts: 1
2003 Ping (Pre-Ignition)
I have 2003 Max SE with engine ping between 1800 and 2200 RPM. Of all the posts I think there are three that are possibilities for the problem.
1. MAF replacement
2. Inefficient cylinder head cooling
3. MPFI vs SFI
Has anyone investigated these possible causes more in depth? If so what was the result? How did you arrive at diagnosing the final solution?
Steve
1. MAF replacement
2. Inefficient cylinder head cooling
3. MPFI vs SFI
Has anyone investigated these possible causes more in depth? If so what was the result? How did you arrive at diagnosing the final solution?
Steve
Member
Joined: May 2009
Posts: 52
From: Houston, TX
Interesting. I had my TB cleaned (rather pay someone $40 than mess it up and have to buy a new DBW TB) and my idle went from around 600 to what appears to be around 725-750 or so. The FSM states that a 700 rpm idle +/- 50 rpm is normal. I haven't noticed that pinging sound since and that is with much quieter tires and doing the rear window wind noise fix so my car is quieter. 
Maybe I am not listening hard enough but it has always been quite faint even when I do hear it.
Maybe I am not listening hard enough but it has always been quite faint even when I do hear it.
I have an annoying driver side rear window wind noise too. Is there a way to fix it besides replacing all of the weather stripping? I figure its just one little piece that's causing a problem.
Senior Member
Joined: Aug 2007
Posts: 700
From: Staten Island,NY
i have this on my 2k i30 too. i happens little pass 2k around 2.1k. its not coming from the engine its coming from under the car near the driver area. Also one of my heat shields fell off one time and i think after a while this sound started to happen.
Junior Member
Joined: Feb 2008
Posts: 98
From: long island, ny
i have the same problem it gets really annoying and makes the car seem like a piece of ****. i think its coming from some part of the exhaust. idk i cant pin point it myself. it cant be the oil, the car performs fine.
I have it but just deal with it. It's not that bad. 6 year old car not worth tearing apart to figure out what is causing it. My car runs awesome except for the rattling at low rpms
Senior Member
Joined: May 2004
Posts: 933
From: Vancouver, BC
You can eliminate the "flooded"? valves & MPI theory. The system normally does operate with SFI. For engine starting and if it ever goes into "limp-home" mode, it operates in MPI mode. Right out of the FSM.
I just want to confirm with everyone else, that its not oil related. Wifes car has been doing this for a few weeks now...Oil level was low, needed an oil change anyways.
Drove it today after the oil change, and still the same issue. And its right around 1900rpms in 4th gear for me. I'm going to try a few things over the next month or so...if anything fixes it I will let everyone know.
Drove it today after the oil change, and still the same issue. And its right around 1900rpms in 4th gear for me. I'm going to try a few things over the next month or so...if anything fixes it I will let everyone know.
Junior Member
Joined: Jun 2003
Posts: 26
From: Cincinnati, OH
I eliminated that rattle sound I was getting around 1800 to 2000 rpm. It turns out that it was a heatshield. The heatshield in question is just forward of the cat, above the flex hose connecting the headers to the cat. Once the mechanic put a clamp on it I have never heard the rattling again.
go earn your post somewhere else nOOb . On a more serious note: It is definetly not the oil level. Just put a k&n filter and synthetic and yeah sure enough still there. It does come from under the car for me....so im thinking that it might be the cat or the heatshields.
Thread
Thread Starter
Forum
Replies
Last Post
tarun900
4th Generation Maxima (1995-1999)
19
Dec 20, 2021 06:57 PM
