Anybody know a good way to seal the rear of the fog housing after installing the umnitza HID fogs? I am lost on this one and can't find a thing when I search. Any help would be great. Thanks guys
Josh

 

ever get this sorted out? Im going to be installing these HIDs on my 01 tomorrow...Im assuming silicone would seal up the drilled hole? Or is the problem that the H3 bulb is too long

 

Bulbs are not too long, and if you need to seal because youre a nub and drilled, then use silicone....done

mine are not from umnitza be you get the idea

 

My issue was the grommet. You need to cut a circle in the back of the housing. If you cut the right size then there is no need for silicone. The regular bulbs are too long, that's why you should order the H3c bulbs. They are smaller and fit. If you order the regular H3 bulbs then you just bend down the light reflector in the housing. Just stick a screw driver in there and bend it down.

 

wish I knew to order the H3c's.....and so much for PnP, any way to avoid the drilling?

And what diameter did you use? Umnitza recommended 1" but 7/8 looks like it might be a better fit

 

precisely! i just soldered and heat wrapped the wires instead of all that mumbo jumbo though...

 

which wires you talking about?

 

are you still trying to make people have a seizure by putting strobes in your break lights? PM me stop posting all over the place about it

 

There is no way to prevent drilling. Just stick with what they say.

 

um yes there is, mine are clearly installed....with no drilling

 

wtf?

 

Explain... how?

 

I was wondering the same thing...

 

my bad....was another dude...with a 6th gen....sorry got yalls names confused

 

Got ya, so how did you now need to drill the back of the housing?

 

Cut and soldered wires then used heat wrap to seal the wires up

 

oh I see. You already said that lol. my bad

 

im still confused, most likely bc i cant remember what the back of the housing looks like

 

np, would you like me to show you the wires when i get home?