HELLO MY FRIENDS JUST HAVE A QUICK Q, ANY OF YOU ALL INSTALL THE PR CAI ON UR 2K2 MAX?? IS IT HARD?? BECAUSE I WANT TO LET MY BOYFRIEND INSTALL IT FOR ME, I HEARD THE ONE ON 2K, IT SOUNDS LIKE "SHHEEEEOOOOO" DAMN GOOD...NEED ALL YOUR ADVISES

THANKS ALL

 

Howdy, not to be a bugger or anything but could you please get rid of the All-caps when posting? Thanks

Anyway, the installation is similar to the pre-2k2's, the worst part of the installation (At least in my opinion) is the drilling of holes - roughly 3 1/2" in diameter. Aside from that, based on everyone's comments and looking at the instruction sheet it doesn't look all that involved compared to the POP and RAM Air intakes.

 

Oh, and to add. Be sure you get the 2k2 version of the CAI and not the pre-2k2's.

PR should already have it available by now, a couple of dealers had it for a week or two now but in very limited numbers. PR's official release date (at least what they've been telling us) should already be in effect (e.g. three weeks ago they said it will start shipping in 2 weeks)

 

Well i just did mine last night(Sat) i have a 2k and it was a pain in the butt, the template was wrong, so now I have a bigger hole than I should, there is a lot of little things that have to get done(take off) and when it goes into the hole (pipe) you can't put the white box back in that holds all the wires, it just dosen't fit(he will have to tape up all the wires, so they don't get wet.
Bernie
make sure you verify the template is for 2k2

 

ya drilling a 3.5 inch hole in your new car is usually not desirable.

 

..3.5? ...that's no drilling...that's punching a hole in ur car!!

 

ya and it's there for ever, to each his own, but i plan on staying stage 2 and 3 when i finish it up.

-steve