hey guys, i just finished adding my 3rd set of hids to my max. i came up with a creative way to install the wiring to the h3 fogs. i cut the wires going into the fog light cap, connected the hid power/ground cable to the oem wires. i was able to run wires to the h3 hid bulb without using a hole drill bit. it takes a little bit of patience but after cutting off the 2 wires, ground and power, i pulled out the oem wires and fed the hid amp connectors. the way i did that was cut the wire, fed it through and soldered/shrink wrapped it afterwards.

just finished a bit ago so sorry if this sounds all jumbled.

btw, i have a 04 max with a 08 oem front end converision minus the hood and headlights.

i have 6k in the headlights, 3k in the bumper fogs and now 6k in the headlight fogs.

 

Cool, any pics??

 

what type of bulbs are you using? and do you have any pics day and night?

 

i should have pix by the end of this week. i got some exams to study for.

im using h3 6k hid bulbs. http://cgi.ebay.com/ebaymotors/ws/eB...m=390102224037

 

something is not right about the ebay post. I mean I have 6k bulbs and they look like the 25k bulbs. I didn't even know bulbs went to 25k. I thought it was 12k for purple or something like that. Also I don't have HID bulbs I have Plasmaglow Bulbs that look like HID. I went that route because it's way cheaper and come with a no questions 10 year free replacement warrenty.

 

dont HID's need ballasts?

 

sorry, i shouldve clarified in my original post, i had some extra ballasts lying around so i went hids.

 

 

^^^ i knew it was coming, lol.