Motor Mount Insert DIY question
#1
Motor Mount Insert DIY question
How can I do this without using an engine hoist? Is there a DIY for this allready? I remember reading one but did a search and can't seem to find it. I plan to do this real soon so all help is greatly appreciated. I have plenty of tools in the garage just not a lift nor an engine hoist <-yet. This could be a good excuse to get one. Also I plan to replace the front and side mounts and add the inserts. The rear will be done when my tranny is done. Thanx again guys.
#2
AFAIK there aren't side mount inserts for the maxima unless you poly fill it.
Just remove them one at a time and leave the motor with holding to 3 mounts. Don't drive with it like that tho.
Just remove them one at a time and leave the motor with holding to 3 mounts. Don't drive with it like that tho.
Last edited by secondtonone317; 11-18-2009 at 06:33 AM.
#3
? Am I missing something? I thought there were only 3 mounts for our cars. 1 side mount passenger side, 1 front mount, 1 rear/transmission mount. I have 2 inserts that I purchased a while back and swear they are for the front and side mount. The rear mount isn't designed the same correct? what is AFAIK? "And For All I Know" ??
Thread
Thread Starter
Forum
Replies
Last Post
vingodine
5th Generation Classifieds (2000-2003)
45
05-21-2016 12:46 PM
Rage Maximus
4th Generation Maxima (1995-1999)
3
09-03-2015 12:26 PM