Auto entry/exit - new battery

Subscribe
Apr 14, 2013 | 04:23 PM
  #1  
I replaced my battery and now the auto entry/exit of the steering wheel and drivers seat do not occur. I checked the settings and they are enabled. Anyone have any clue as to what I can do to regain that function? Thanks
Reply
Sep 12, 2013 | 03:07 PM
  #2  
I just experienced the same problem. This did not happen with my 1st battery replacement. Baffled since all fuses are good. Has to be a way to reset it like the sunroof.
Reply
Sep 14, 2013 | 04:15 AM
  #3  
Driving enough must have fixed it. Otherwise try:

- Insert key in ignition and turn the key to ON position.
- Open and close the drivers door 2-3 times.
- Close door
- Start engine
- Turn engine OFF
- Remove key
- Open door.

The automatic driver position should work now.

If the above doesn't work, try disconnecting the car battery for about 5-10 minutes and reprogram the system memory again.
Reply
Nov 6, 2013 | 12:47 PM
  #4  
Quote: Driving enough must have fixed it. Otherwise try:

- Insert key in ignition and turn the key to ON position.
- Open and close the drivers door 2-3 times.
- Close door
- Start engine
- Turn engine OFF
- Remove key
- Open door.

The automatic driver position should work now.

If the above doesn't work, try disconnecting the car battery for about 5-10 minutes and reprogram the system memory again.
To add a comment to your post:
Is why I let Nissan install my batteries in my 2008 because this problems always shows up and I thought at one time they went into the computer to reset the seats and it may also mess up the sun roof. I'll keep your method in mind, thanks
Reply
Subscribe