Any way to fill/seal a super tiny chip in fog light?
#1
Any way to fill/seal a super tiny chip in fog light?
I noticed some condensation forming in my fog light. Upon further inspection, I was able to find the cause - a REALLY small chip that is allowing air/moisture into the assembly. I've already had to replace one cracked fog light in less than 6 months of owning this car.
Is there anything I can do to fill or seal this microscopic chip?
Is there anything I can do to fill or seal this microscopic chip?
#3
I'd use "Amazing Goop" over clear silicone. Silicone can turn yellow over time and dries thicker than applied. The goop stuff on the other hand stays clear and dries just as thin as applied. You can buy it at your local hardware store (Home Depot, Lowe's etc.)
#5
Thread
Thread Starter
Forum
Replies
Last Post
The Frye
7th Generation Maxima (2009-2015)
6
09-02-2021 11:03 AM
Maxima30
5th Generation Maxima (2000-2003)
2
09-07-2015 06:13 PM
sdotcarter
6th Generation Maxima (2004-2008)
2
09-02-2015 09:53 PM