Hey guys, just purchased yellow fog overlays from Lamin-X. Thought they would just install from the outside but noticed that isn't going to work. I need specific instructions on how to if I need to go from the inside. Thanks

Why won't it work, I put mine on over three years ago and they still work fine.

It works fine, there is a youtube vid like 10 min long on how to do it. If you mean taking bumper off for easier fitment then there is a thread for that. You definitely dont want it on the inside

I have had mine on the outside for over 3 years also with no problems.

Sorry guys I didn't explain more enough. Do I have to take off the bumper to put them on? When I go to put them on as they sit the film is too big. How do I get to them to have the right fitment. Thanks

I did not have to remove the bumper nor were they too big. Just peel and stick. clean the lenses really good before you put them on. If they are too big you might have to trim them down a bit to get them to fit.

See what I mean

They might have sent film for another car. When I put mine on it was a perfect fit, covered just the lens.

Get an Xacto blade and trim it down. Looks like they sent the wrong size like Richard said because mine was an exact fit.

Called lamin-x and talked to a customer rep. They said that their is two types of sizes and they sent me the bigger one. They are sending replacements out free of charge.

Well that is good news!

To those who have Lamin-x on their fogs, did you notice any loss in brightness?

No sir just a color change.