I just finished up the 00VI install using the 4th gen lower plenum, 5th upper plenum, 5th gen TB, and 4th gen IACV. All hoses are hooked up. I start the car, and it idles at around 400-500 rpm, then it starts to fluctuates like crazy going up and down from 100-700 rpm, I also throw a code. I am thowring the 1302 code which is the "MAP Solenoid Valve or Circuit Fault" Any dieas on how to fix the erratic idle and the code? Maybe I should reroute some vacuum lines or there is a leak..

 

Double check your vaccum lines. And make sure your MAP sensor has a vaccum source. Mind didn't and I threw a code.

 

now i have the 0701 code to follow the 1302, so now im throwing both the 1302 and 0701 codes...any ideas on what i should look for?

 

Sounds like vacuum/air line routings to me too.

 

how long did it take you to install it? how hard was the total install?

 

took too long because i had to keep on going to OSH to buy screws, hoses, clamps, and elbows, and it was a ***** to install....not the easiest thing to install, and after the install, it didnt run well and i had to smog within a few days, so i had to take it all off and install the stock 4th gen manifold again which probably took a good 3-4 hours, hopefully someone can help me with my problems after my smog check which i failed, which is another story