2k Lower IM swirl valves
#1
Hella internets
Thread Starter
iTrader: (13)
Join Date: Oct 2003
Location: Sacramento, CA
Posts: 3,808
2k Lower IM swirl valves
I am attempting to remove these, as i left them in when i did the install, i just jb welded the outer holes (2) but im noticing that without the rod (for butterfly valves) the holes between each cylinder are wide open (not sealed). When you guys sealed the outer two holes did you also seal these? im assuming air will cross between cylinders, causing a loss in efficiency....
I noticed that no one has even brought these holes up, should i just leave them open?
Thoughts?
I noticed that no one has even brought these holes up, should i just leave them open?
Thoughts?
#3
Hella internets
Thread Starter
iTrader: (13)
Join Date: Oct 2003
Location: Sacramento, CA
Posts: 3,808
Originally Posted by SDot82
I just sealed the outer holes and I just left the inner holes alone. But thinking back on it I should have oh well.
Thread
Thread Starter
Forum
Replies
Last Post
MaxLvr21
5th Generation Maxima (2000-2003)
14
10-17-2015 12:11 PM
tseng1023
5th Generation Classifieds (2000-2003)
3
10-15-2015 08:30 AM
DC_Juggernaut
7th Generation Maxima (2009-2015)
4
09-28-2015 04:07 PM