Emanage ultimate question
#2
Thread Starter
Supporting Maxima.org Member
iTrader: (6)
Joined: Jul 2002
Posts: 2,063
From: Reno, NV
Nevermind I found that. Although I had another problem. When I connected the emanage to my computer with the USB cable it said that there was an error. So uninstalled everything and reinstalled and even now everytime I try and connect the EU to the computer nothing happens. It's not even recognizing that something is connected. Does anyone have any ideas as to why this is happening?
#3
Go here http://www.mohdparts.com/emanage/ and get the latest software/firmware 114 right now.
Download the update, when you run the software and are connected to the EU it will automatically update the latest firmware if its on your computer.
See Page 9 of the manual.
Download the update, when you run the software and are connected to the EU it will automatically update the latest firmware if its on your computer.
See Page 9 of the manual.
#8
Originally Posted by Kevlo911
Jim, any details on the bigger maf housing but our element?
Tried it out a few minutes ago. A little chugging upon startup but once I got the a/f set its fine. I had to add 35% fuel down low and 60% at WOT. Not sure yet how its going to work but it only takes 2 mins to change so I will be doing a lot of comparing ie timed runs etc.
I got the 3.5" aluminum tubing, the 3.5 filter and the 3-3.5 silicone adapter from Vibrant Performance.
#10
Originally Posted by Kevlo911
I see. Were you maxing out the maf?
Basically trying to see if the CP-E setup for the Altima, which is basically the same as what I have done, helps any or just a myth to make money.
Thread
Thread Starter
Forum
Replies
Last Post
Unclejunebug
5th Generation Maxima (2000-2003)
10
04-02-2016 05:42 AM
Stagnet04
4th Generation Classifieds (1995-1999)
2
10-11-2015 08:16 PM