Well i hocked everyhing up im getting fuel and everything but im not getting no spak. ECU codes EVAP control system and EGR Temp sensor thats it. I checked the cam sensors nothing please let me know what else can it be thx

 

Check to make sure everything is grounded, alternator positive is put on correctly and nothing is arcing. Check starter, etc. It's probably a wiring issue.

 

Alright I just checked all ground i still get no spark. anything else that it could be.

 

Double check everything is plugged in. Especially the crank sensors. So the starter is turning just fine?

 

What oil pan did you use? What crank pulley?

 

Im using 3.0 oil pan and im using the 3.0 crank pulley


i checked to see the crank sensors the apear to be pluged in fine and the starter is just turning i am getting fuel

 

check with page EC-336 of the FSM.

 

is the main harness ground connected? make sure one of the vacuum hoses aren't disconnected.

make sure the cam/phase/pos are all pluged in and wires/harnesses aren't cut/damaged. make sure they are correctly plugged in, i.e. the 95 ecu has a switched Cam+phase in the ecu pin outs.

Make sure the 5th gen injector plugs have been spliced correctly to the 4th gen wires

good luck, maybe post a pic or two of the harness?

 

what was the reason urmad engine wasn't sparking

 

I meant urmab

 

Did you replace the flywheel or use the original? I'm asking this because, if you don't already know, I used a Fidanza and the guy who installed it for me forgot to transfer the timing ring over. No spark was my problem as well as the crank sensor had nothing to read.

 

I used the original 3.0 flywheel

 

Is it no spark for all six cylinders?

 

^^ I think so.. Since the timing ring wasnt installed there was no signal.