maximusberg

iTrader: (1)

ok so originally i had the safc2 wired up (yellow wire to yellow wire), and (white to white wire) as the input and out puts...after i cleared the safc2 and started the car up again the engine light came on. p0101 and p0103 codes both popped up ( car was not in limp mode tho.)...

i tired to re wire it using the (pink to yellow) and (orange to white wires) as it says to and started it up and the engine light came back on and was in limp mode this time.......

i had tried a third way now switching the (pink to white ) and the (orange to yellow) a nd now the car wont start at all, and the engine light is on with the same engine codes!
(p0101 & p0103)

if someone could tell me whats wrong here... i dunno if the controller went bad on me or if the inputs and outputs are wrong? but i dont get what just happened?

so now i disconnected the controller completely and the car starts up fine

NmexMAX

iTrader: (22)

What directions were you following?

maximusberg

iTrader: (1)

http://my6thgen.org/f17/apexi-safc2-125/

t6378tp

iTrader: (69)

What settings did you use