Speebs

iTrader: (2)

To those who have the Basslink with the remote LC...


Where and how did you mount your ****? I'd like to replace the cigarette lighter with the **** but I can't figure out how to attach it to the trim. Any ideas?

Thanks,

Doug

Ryan93SE

iTrader: (1)

i mounted mine by just sticking it down between the passenger seat and the center console.... it fits nicely there and didnt have to trim anything

Speebs

iTrader: (2)

That's a good idea but my passenger seat moves quite a bit... and I share my car with my sister so the driver's seat does too

Speebs

iTrader: (2)

JDM4LIFE

iTrader: (2)

i've mounted some switches i've had in my car underneath the dash on the driver's side. if you feel down under the dash directly below the steering wheel, you'll notice there's a nice small, flat lip at the bottom of the dash where you could mount anything along there. i've got the switch mounted for my line mod on the flat lip where it sits directly below the fuse panel. not the easiest place to reach, but i can easily hit switches, etc. there if needed.

2kSeattleMax

I put mine in one of the plastic blanks (just the adjustment ****) to the left of the wheel on the drivers side.

Speebs

iTrader: (2)

I saw that on your web page... but how did you mount the PCB? What did you attach it to?


Thanks,

Doug

Speebs

iTrader: (2)

I saw that on your web page... but how did you mount the PCB? What did you attach it to?


Thanks,

Doug

mzmtg

iTrader: (11)

Back when I had a sub-processor, I had it mounted in the center console. The level **** was towards the front, so I could just lift the lid a little with my fingers and adjust it. Out of sight, but still accessible.