One 12" Power Acoustic Kevlar Farenheit Subwoofer (1000 rms/2000 peak)pushed by a Profile 1200sx Amplifier (900x1 rms). I also plan on getting a crossover for the sub so it doesn't play so high. Any recommendations. I have a sealed box, but I don't have the measurements. Any estimates on the dB would be great. Thanks in advance. Also, does anybody have a custom installation to save space in the trunk, or any recommendations.

CK-12D

Kevlar Fiber, Ceramic Coated Cone
Oversize Butyl Rubber Surround
Dual Hybrid 4 Layer 4 Ohm Voice Coil
3" High Temperature A.S.V. Voice Coil
Low Q Driver (.75~1 CUFT. Sealed Box)
224 oz. Magnet Structure
Maximum Input 2000 Watts
R.M.S. Input 1000 Watts
Imp. 2 Ohm, 4 Ohm, 8 Ohm
Freq. Resp. 18Hz-1kHz

1200sx

2-ohm stable in stereo
450 watts x 2 into 2 ohms
600 watts x 2 peak power
900 watts in bridged mode
continuously-variable high-pass and low-pass crossovers (40-130 Hz at 12 dB per octave)
105 dB signal-to-noise ratio
45 Hz bass boost (continuously variable, 0-12dB)

 

dude...how much are you getting this stuff for? those are really low end manufacturers with inflated specs...email me and i will help you out...

 

i have a kenford 9000 watt amp (pmpo)and a kracko 8" triple voice coil with a 10 inches throw... i bet i can get 178DB's out of this thing.... buy the way im running telephone wires for all the amplifier connections

 

your system is straight ghetto

 

but my car sure does look good

 

hey ray89se- how did you wire the neon to the doors? did you solder longer wires? did you run the wires straight to the battery?

 

wesley:

I'd certainly look for other brands, these guys are trying to steer you away from a pretty bad brand of car audio equipment for a good reason.