Audio and Electronics Discuss in-car entertainment systems, audio and video systems, car alarms and other electronics topics.

Potentially using higher RMS than speaker supposedly can handle

Old Sep 25, 2003 | 07:26 PM
  #1  
GarthG's Avatar
Thread Starter
Supporting Maxima.org Member
iTrader: (1)
 
Joined: Aug 2000
Posts: 2,619
Potentially using higher RMS than speaker supposedly can handle

I have MB Quart Mobile 160.30 kx (4 or 5 years old) and with my old set up I was running a PPI PC4400 amp to power the front and rear speakers (potentially 50W RMS to each). Well today I decided to bridge the front speakers and hook the rears up to the deck. While I think the sound is much improved with the higher power (Potentially 100W RMS) I am concerned because the peak power handling of the speakers is 85W. I know that they can get too hot if played at high volumes, but do I have to worry about extended playing time even at normal volumes? Also does anyone think I will have any issues running this setup? Any help is appreciated.

Summary:
-Running 100W RMS to a speaker that has a peak power handling of 85 RMS, bad at normal volumes for long periods?

-Anyone advise against this? If so, reasons?
Old Sep 26, 2003 | 09:12 AM
  #2  
Maxima Dan's Avatar
Senior Member
 
Joined: Aug 2002
Posts: 719
I really wouldn't worry about burning out the voice coil, you will over extend the mid before that. If you hear it bottoming out, turn the volume down. That said, I have always run my front end with 125W RMS per channel and have only torn the surround on one speaker. Oh yeah, I broke the tinsel lead off another. But that was more a freak accident and a moment of stupidity. Bottom line is that if you are careful you shouldn't have any problems.
Old Sep 26, 2003 | 12:51 PM
  #3  
soundmike's Avatar
Very sound, Mike
iTrader: (24)
 
Joined: Sep 2001
Posts: 6,011
From: H-Town
From what i learned, it's better to have an amp that's powered higher than your speaker can handle.

Why? Because if your amp is of so-so quality, there's a good chance your speakers will clip and that's a bad thing.
Old Sep 27, 2003 | 09:59 AM
  #4  
TAPOUT's Avatar
You will lose
iTrader: (5)
 
Joined: Feb 2003
Posts: 6,783
From: Ft. Myers Florida
You will be fine....You have the blessings of the Audio Gods. Just remember to set up the crossover.
Old Sep 27, 2003 | 02:18 PM
  #5  
GarthG's Avatar
Thread Starter
Supporting Maxima.org Member
iTrader: (1)
 
Joined: Aug 2000
Posts: 2,619
Originally Posted by TAPOUT
You will be fine....You have the blessings of the Audio Gods. Just remember to set up the crossover.
I made sure the crossover is set up correctly. . . And it has protection circuitry for the tweeter. . . I am typically careful with my system and never have seen just how loud it can go, but I figure that as long as I don't push the mids too hard, and pay attention if the circuitry protects the tweeter, then I will be fine. Thanks for all your guy's help.
Old Sep 29, 2003 | 05:37 PM
  #6  
gtbigup's Avatar
Donating Maxima.org Member
 
Joined: Feb 2003
Posts: 252
You should be fine just dont turn your system up too loud.If you start to hear distortion you're too loud and stand a chance of burning up the voice coil.The 15 watt rms is not a big deal though
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
REDinLV
7th Generation Maxima (2009-2015)
5
Aug 15, 2024 12:30 AM
magiconthetire
Audio and Electronics
2
Oct 26, 2015 09:03 PM
220k+ A32
5th Generation Maxima (2000-2003)
25
Oct 3, 2015 09:09 PM
Kyle Lee Cleveland
Audio and Electronics
1
Sep 28, 2015 09:03 AM


Thread Tools
Search this Thread

All times are GMT -7. The time now is 01:06 PM.