Questions about putting speakers in a 98 non-bose
#1
Questions about putting speakers in a 98 non-bose
OK, so I recently had to get a new maxima after my 95 had frame damage. I had a Kenwood deck and some basic Alpine speakers in my 95. The Kenwood deck no longer plays CDs so I'm not putting it in the 98. I do want to put the speakers in however and I do not have enough money to get the eclipse deck I want at the moment.
My question is this, if I am going to leave the OEM non-bose HU in and I put in new speakers, I don't need anything special like I know would be needed if it were a bose HU, right? Has anybody here run aftermarket speakers off a non-bose HU? Can you tell any difference or should I wait until I have enough money for a new eclipse HU (which may not be for a LONG, LONG time)? Thanks in advance.
Brian
My question is this, if I am going to leave the OEM non-bose HU in and I put in new speakers, I don't need anything special like I know would be needed if it were a bose HU, right? Has anybody here run aftermarket speakers off a non-bose HU? Can you tell any difference or should I wait until I have enough money for a new eclipse HU (which may not be for a LONG, LONG time)? Thanks in advance.
Brian
#2
NO PROBLEM! Just went out and measured my (unhooked up) rear speakers from my 98 that did have the non-bose. It was running a tad over 4 ohms...so your standard 4 ohm speakers well be an easy fit for that HU just as you'd expect.....
Thread
Thread Starter
Forum
Replies
Last Post
jskirwin
7th Generation Maxima (2009-2015)
7
06-08-2016 08:49 AM