Anyone here do Autocad design of their install?
#1
Anyone here do Autocad design of their install?
I Just designed a box in autocad for a woofer.
My question to you guys is...
anyone have the maxima trunk in autocad? That would be so nice to visualize and fit everything pre-hand and see any possible fitment issues you might run into.
Or does anyone have at least measurements of all different dimensions of the trunk?
I am referring to 5th gen btw.
Thanks.
My question to you guys is...
anyone have the maxima trunk in autocad? That would be so nice to visualize and fit everything pre-hand and see any possible fitment issues you might run into.
Or does anyone have at least measurements of all different dimensions of the trunk?
I am referring to 5th gen btw.
Thanks.
#3
I don't have an AutoCAD schematic or dimensions, but on a related note, I did design my box in ProEngineer. It really wasn't necessary, but I figured why not let the program figure out the dimensions for me. I can see where AutoCAD might be good for laying out the trunk though.
#4
Yeah, I designed my box in autocad also.
Made it quite nice, a flush install
Some pictures:
My "woofer":
Box Front:
Box Iso View:
Flush Fit:
So if anyone here has at least a normal picture of the car, with the measurements.. I would not mind making the trunk in autocad.
Also, after this is done... it needs to be stickied!
Made it quite nice, a flush install
Some pictures:
My "woofer":
Box Front:
Box Iso View:
Flush Fit:
So if anyone here has at least a normal picture of the car, with the measurements.. I would not mind making the trunk in autocad.
Also, after this is done... it needs to be stickied!
Thread
Thread Starter
Forum
Replies
Last Post
RWCreative
4th Generation Maxima (1995-1999)
9
09-21-2015 11:01 AM
QueensMAX
5th Generation Maxima (2000-2003)
7
09-15-2015 04:14 AM
carid
Group Deals / Sponsors Forum
0
09-09-2015 05:06 AM